Shift Check

Sources checked

Virtual shifting not working on Zwift or ROUVY?

Watch the gear number and feel the pedal load. If the number never moves, check controller pairing. If it moves but the pedals feel the same, check trainer control on a free ride before replacing your cassette or Cog.

No virtual gears appear

Check the exact trainer generation and app. For example, a Wahoo KICKR v4 can accept a Cog on the stock HG freehub, but the trainer cannot perform native shifts. A compatible cassette lets you ride it using the bike’s gears. See the v4 in the compatibility guide.

Zwift. On a supported trainer, use Bluetooth for the first test. Pair the trainer under Resistance and the handlebar device under Controls. Enable Virtual Shifting under Hardware. Zwift troubleshooting.

ROUVY. Pair the trainer under Smart trainer. Check the Virtual shifting toggle and enable the on-screen buttons. Add the handlebars separately under Cycling remote control. ROUVY setup and controls.

The screen buttons work, but the handlebars do nothing

On ROUVY, if the on-screen buttons change the load, the trainer has already responded in this session. Check the remote before buying a Cog. One CORE 2 owner recovered handlebar shifting by separately pairing the Zwift Ride controls. That case used Ride handlebars; Play has its own firmware requirement. CORE 2 rider’s follow-up · ROUVY controller requirements.

The gear number changes, but resistance stays flat

Use a free ride with ERG off. In ERG the trainer adjusts resistance to hold target power, which makes the effect of a shift hard to isolate. Use this repeat test for each app separately.

  1. Fix the conditions. Find a constant grade, keep the same physical gear and choose a cadence you can hold. Record the app, trainer and controller versions, connection path and power source.
  2. Ride low → high → original low. Hold each virtual gear for 60 seconds. Record grade, average cadence and watts for the final 30 seconds, and how the pedals feel.
  3. Repeat after reconnecting. Disconnect the trainer and controls, restart the app and pair them the same way. Use the same grade, cadence and three gears.

Look for sustained higher power and heavier pedals in high gear, followed by a return near the initial low gear in both runs. Repeat a segment if grade or cadence drifts. Leave missing measurements pending.

Record my two runs →

What if resistance returns only briefly?

A KICKR v6 owner reported that changing the wheel circumference helped briefly before resistance faded again. A first-generation CORE owner could feel more variation after rechecking that setting, but the low gears still felt similar. Keep the two runs and check the correct circumference in the trainer app before repeating the test. KICKR v6 follow-up · First-generation CORE follow-up.

For CORE 2 with an existing cassette and Play 2.0.1 or later, we have no controlled two-run record on either platform. The checker shows the firmware limits and the observations that are available. Check CORE 2 with Play.